Perkinsville, Vermont
unissamog: Carbon-bike-project in: Bikes - All Mountain/Enduro
206 views
Here you can see the ridges in the epoxy left by the compression wrap.
183 views
1st carbon cured. Learning, but this shape is way harder than a basic tube.
230 views
Another view
196 views
1st carbon fiber actually on the bike. Shown with compression wrap.
205 views
tubes getting some nicer shapes, and the metal parts now fiberglassed
161 views
Another view of the fiberglassed metal parts.
203 views
Headtube, seattube and bottom bracket were roughed and then wrapped with epoxied fiberglass to insulate the metal from the carbon fiber and eliminate possible galvanic corrosion. They are shown here with their compression wraps in place.
199 views
Bottom bracket roughing
168 views
Another view of the texture
182 views
Some "surfacing" done to the headtube for adhesion.
202 views
Laying out the whole front end.
229 views
1st tube being roughed in.
It's good to have friends. I borrowed a front triangle frame jig from my local frame builder. Thanks Frank!!
185 views
1st carbon layup, not too bad, still a bunch to learn.
157 views
Some of the few non-carbon parts used in the build
141 views
Hard parts. from top to bottom seat tube shim , bottom bracket and head tube.
211 views
Closeup of excess epoxy weeping through perforated electrical tape compression wrap.
197 views
Core wrapped carbon fiber and then compression wrapped with perforated electrical tape. Excess epoxy is leaking through the perforations.
231 views
Laying out everything in preparation for epoxy mixing.
201 views
Another core shot
1st core experiment. It is pink insulation foam board cut and shaped
unissamog: buysell in: Parts - Suspension
521 views | 1 comments
About Us
Advertise
Cool Features
RSS