3 months, one weird issue was the standard bar clamp didn’t tighten down all the way. Had to make a shim with tape on my bars.
You've assembled the OneUp remote incorrect, find a picture on the web or contact OneUp for a photo. I had the same problem, emailed OneUp and soon as I saw the photo it was self-explanatory. I don't why they didn't include a photo of assembly, very confusing!
Having serviced my E13 again the bearings were covered in brown slurry type dirt...god knows how the dirt gets in! Anyway the post just about returns to the top and the gap where the brass key sits to keep the seat from wiggling has widened so its now the play is very noticeable. Luckily Santa has provided a decent amount of Wiggle vouchers so looking at the reverb 170 with the new 1x lever as they no longer sell the one up post which is a pity.
I actually just swapped out my Oneup dropper for my Reverb B1 that I had in the bin. Personally - I prefer the Reverb just because it extends faster with that top-out “clunk” sound. I did convert it to cable as well
Mine has been trouble free in freezing temperatures. Still nice and quick up and down. Not had much sub-zero temps though. Run mine at 170mm with a Wolftooth remote. It's the best post I've used. Had 2 Reverbs, a KS lev and a Brand X before this.
Just installed a 170mm One Up dropper (version 1) and it is dropping fully when I sit on it (or push down). I’m pretty sure I followed the instructions properly, but am I missing something?
I’ve emailed One Up but thought I’d throw it out to the pink bike collective
One-Up dropper return speed can be altered by increasing PSI. I think recommended PSI is 250-300psi. I set mine at 295 and it snaps up just as quick as a Reverb.